Feature/Code Selection
Sending a fax at a specific
time
MBNM4NM1NM2N
This feature allows you to take advantage of low-cost calling hours offered by
your telephone company. This feature can be set up to 24 hours in advance of
the desired time.
M0N “OFF” (default)
M1N “ON”
To send a document:
1. If the MFaxN light is OFF, turn it ON by pressing MFaxN repeatedly.
2. Set the original (page 18).
3. If necessary, change the contrast (page 38) and the resolution (page 38).
4. MMenuN A MBNM4NM1NM2N
5. Press M1N to select “ON”. A MSetN
6. Enter the fax number.
R To enter an item using phonebook, see step 3 on “6.3 Sending a fax
using phonebook”, page 40. (When using phonebook, you do not have
to press MEN before pressing MCN or MDN.)
7. MSetN
8. Enter the transmission start time.
R If you selected 12-hour time entry (page 20), press MHN repeatedly to
select AM or PM.
R If you selected 24-hour time entry (page 20), the time is set using
24-hour time entry.
9. When using the scanner glass, press MSetN. A MStartN
When using the automatic document feeder, press MSetN (KX-MB1530
only).
R The document will be scanned into memory. The unit will then send the
data at the specified time. You cannot use this feature for another fax
transmission until the former sending is completed.
Note:
R To cancel this setting after programming, press MStopN while the unit is idle,
and then press MSetN.
Setting the Error Correction
Mode (ECM)
MBNM4NM1NM3N
This feature is available when the sending / receiving fax machines are ECM
compatible.
M0N “OFF”: Deactivates this feature.
M1N “ON” (default): Fax transmission / reception will be carried out so that the
errors do not occur.
Setting the connecting tone
MBNM4NM1NM6N
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party’s machine.
M0N “OFF”: Deactivates this feature.
M1N “ON” (default): You will hear connecting tones.
Note:
R If the ring back tone continues, the other party’s machine may not be a fax
machine or may have run out of paper. Check with the other party.
R The connecting tone volume cannot be adjusted.
Setting the maximum fax
speed
MBNM4NM1NM8N
M1N “14.4kbps”
M2N “33.6kbps” (default)
Note:
R The fax speed maybe lower than the selected speed depending on your line.
Setting the quick scan mode
MBNM4NM1NM9N
(KX-MB1530 only)
M0N “OFF” (default): Deactivates this feature.
M1N “ALWAYS”: The unit will scan the document and store it into memory first,
then the unit will start sending the documents.
57
8. Programmable Features
To Next Page
Loading...
