Panasonic KX-MB2100 series - Page 70

Separate N in 1
“2 in 1” “4 in 1”
Original document
(“PORTRAIT”)
Separate pages
1 Set the original.
2 Mo/PAGE LAYOUTN (repeatedly): “PAGE LAYOUT”
3 MCDN: “SEPARATE N in 1” A MOK/SETN
4 MCDN: Select the number of original documents. A MOK/SETN
5 MCDN: Select the page layout of the original documents. A MOK/SETN
6 If necessary, enter the number of copies (up to 99).
7 Mx/STARTN
Note:
R After you finish copying, press Mw/STOPN to reset this feature.
7.2.8 Booklet feature
You can make copies, and then fold them in half to create booklets. The documents will be reduced to fit the recording
paper.
8
7
6
5
4
3
2
1
1, 2
3, 4
5, 6
7, 8
1 Set the original.
2 Mo/PAGE LAYOUTN (repeatedly): “PAGE LAYOUT”
3 MCDN: “BOOKLET” A MOK/SETN
4 MCDN: “LEFT BIND” or “RIGHT BIND” A MOK/SETN
5 MCDN: Select the desired binding pages.
– “1”: Makes a booklet with every 4 documents printed as separate blocks.
– “ALL”: Makes a booklet with all documents printed as 1 block.
6 MOK/SETN
7 If necessary, enter the number of copies (up to 99).
8 Start copying.
When using the scanner glass:
1. Mx/STARTN
R The unit will scan 1 page.
2. Place the next page on the scanner glass and press MOK/SETN. Repeat this until you have scanned all pages.
70
7. Copying