149
KX-MC6020HX
5 The [Connect Type] dialogue box appears.
For USB connection
1. [Connect directly with a USB cable.] → [Next]
• The [Connect Device] dialogue box will appear.
2. Connect the unit to a computer with the USB cable (1), then click [Next].
• If the unit is connected to your computer, the model name will be automatically detected.
• You can change the name of the unit if necessary.
3. Click [Install], then follow the on-screen instructions.
• The files will be copied to your computer.
For LAN connection
1. [Connect via the Network. ] → [Next ]
• The [Select a Network Device ] dialogue box will appear.
2. Check [Select in the searched list] and select the unit from the list.
• If the name of the desired unit is not displayed on the list, and the IP address for the unit has been assigned, check [Direct
input] and enter the IP address.
3. [Next]
• You can change the name of the unit if necessary.
4. Click [Install], then follow the on-screen instructions.
• The files will be copied to your computer.
Important notice
If you use Windows XP or Windows Vista, a message may appear after connecting the unit with the USB cable. This is normal
and the software will not cause any difficulties with your operating system. You can continue the installation with no problem.
This kind of message is displayed:
• For Windows XP users
“The software you are installing for this hardware has not passed Windows Logo testing to verify its compatibility with Windows
XP”
• For Windows Vista users
"Would you like to install this device software?"
To Next Page
Loading...
