170
KX-MC6020HX
• Recording paper is not installed or the paper input tray has run out of paper. Install paper.
• Recording paper is not fed into the unit properly. Reinstall paper.
Note:
• “#1”: Standard input tray
• "#2": Optional input tray
• "#1+#2": Standard input tray and optional input tray
• A recording paper jam occurred. See the other displayed message instructions to remove the jammed
paper.
• The cable or the computer power cord is not connected correctly. Check the connections.
• The software is not running on the computer. Restart the software and try again.
• The unit is warming up. Wait for a while.
• The other party’s fax machine does not offer the polling function. Check with the other party.
• The other party’s fax machine is busy or has run out of recording paper. Try again.
• The document is jammed. Remove the jammed document.
• Attempted to send or copy a document longer than 600 mm using the automatic document feeder. Press
[Stop] to remove the document. Divide the document into two or more sheets and try again.
• The memory is full of received documents due to a lack of recording paper or a recording paper jam. Install
paper or remove the jammed paper.
• If feature #442 is set to "ALWAYS" on Program Mode Table (P.176),
- check the connection between the computer and the unit.
- check the computer is turned ON.
• There is something wrong with the scanner position. Turn the power switch OFF, then ON.
• The unit is changing the colour calibration. Wait for a while.
• A transmission error occurred. Try again.
• The toner cartridge is not installed. Install it.
• The left cover of the optional input tray is open. Close it.
• The waste toner cartridge life is near its end. Replace the waste toner cartridge as soon as possible.
• The waste toner cartridge is not installed. Install it.
• The waste toner cartridge life is finished. Replace the waste toner cartridge immediately.
DISPLAY MESSAGE CAUSE AND REMEDY
To Next Page
Loading...
