Panasonic KX-NCP1000 - Option Tab

3/21/2013 10
Rev1
Basic Channel setup:
Please locate the OnSIP SIP Trunks account details from your OnSIP
account Welcome letter/email....
o Main tab:
According to the standard OnSIP SIP trunk account, we need to configure the Basic Channel Port
as follows:
“Please Note: the information provided below is just a sample, please locate
your account details in your OnSIP welcome letter/email”
1- Port 1 channel attribute = Basic channel
2- Provider name= OnSIP
3- SIP Server Name= “sip.onsip.com ”
4- SIP server port number =5060
5- SIP service Domain = “[username].onsip.com” example :
panasonic.onsip.com where panasonic is Username provided by OnSip
6- Subscriber number = 1234567890 (OnSIP Account DID/BTN)
o Account tab:
1- user name == ( Please provide your account sip username) example=
panasonic
2- Authentication ID== same asUsername
3- Password == ( Please provide your account Authentication Password, Case
sensitive entry)
o Register Tab:
Changes from Default settings:
1- Register server address= “[username].onsip.com” example :
panasonic.onsip.com where panasonic is Username provided by OnSip
o NAT Tab:
Same as default
o Option Tab:
Same as default
o Calling Party tab:
Same as default
o Called party Tab:
Same as default