3/21/2013 11
Rev1
o Voice/Fax Tab:
Changes from Default settings:
1- 1
st
Codec Priority = G.711u
2- 2
nd
Codec Priority = G.729a
3- 3
rd
Codec Prioirty = G.711a
o RTP/RTCP Tab:
Same as default
o T.38, T.38 Option
Same as default
o DSP
Same as default
o Supplementry services:
Changes from Default settings:
1- CNIP (Receive) = Yes ( All Channels, Basic and Additional)
Additional DID’s
Please set the channel attribute for number of ports depending on the number of
active SIP lines as”additonal channel for channel 1”
For example ,if there are 3 Simultaneous calls can be received on this trunk, the
number of V-SIPGW ports to be set as an”additonal channel for channel 1”will be
2 ports
To Next Page
Loading...
