To assign the IP address of the IP-CS, the subnet mask address, and the default gateway address
manually, refer to corresponding manuals for the IP
-CS.
If you need to set VLAN parameters, refer to corresponding manuals for the IP-CS.
Not using a DHCP server (DHCP Server feature or an external DHCP server) when the IP-CS is on a
remote office LAN
All of the IP addressing information must be assigned manually.
To assign the IP addressing information, refer to corresponding manuals for the IP-CS.
If you need to set VLAN parameters, refer to corresponding manuals for the IP-CS.
Note
By assigning the PBX’s IP address to one IP-CS (KX-NS0154
only), it is possible to assign the PBX’s IP
address to other IP-PTs or IP-CSs on the same LAN through system programming. For details, refer to
"9.18 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-IPCS—Option—
Announce
Mode" in the PC Programming Manual.
Document Version 2016-03 Installation Manual 203
5.7.1 Assigning IP Addressing Information
To Next Page
Loading...
Need help?
General