Transmit Extension Status Information Functions
Enabled
• Transmit information on own PBX extensions
• Receive
information from other PBXs; forward it to other QSIG ports of
the PBX
• Re-transmit information received by other QSIG ports of the PBX
Disabled
• Receive
information from other PBXs; forward it to other QSIG ports of
the PBX
Set the transmission setting for each port according to the layout of your network, so that extension status
information can travel between NDSS monitor PBXs.
[Example ISDN Network Port Setting]
PBX-1
Network ID 1
PBX-2
Network ID 0
4001
Idle Busy
OFF
OFF
ON
ON
ONOFF
OFFOFF
ON
4001
Busy
4001
Busy
4001
Busy
PBX-3
PBX-5
PBX-4
Network ID 3
Idle
4001 NDSS
Busy
IP-Gateway-QSIG
IP data is routed through the network according to the routing tables of the
V-IPGW cards. When using
VoIP, it is necessary to identify the monitor PBXs, to which to transmit extension status information, for
each card that will be used. This is done by specifying the extension number of any extension (for example,
the PBX operator) at the monitor PBX as a Network Operator extension for that V-IPGW card.
Document Version 2016-03 Feature Manual 301
15.1.14 Private Network Features—NDSS (Network Direct Station Selection)
To Next Page
Loading...
