Panasonic KX-NS1000 - Page 321

Automatic Rerouting of VoIP Calls to Public CO lines using ARS
When dialing an outside party using ARS, the call can be rerouted to a public CO line if the call cannot be
completed successfully.
(012-345-1011)
PBX-1 PBX-2
Extn.1000
V-IPGW
V-IPGW
Dials
"9-012-345-1011"
Private IP
Network
Telephone Company
(area code: 098)
Telephone Company
(area code: 012)
012-345-1011
Explanation:
1. An extension of PBX-1 dials the Idle Line Access number of PBX-1 "9" and telephone number
"012-345-1011".
2. PBX-1 modifies and routes the call to PBX-2 through a private IP network according to the ARS
programming of PBX-1.
3. The IP network transmission cannot be completed successfully and the call is rerouted via a public CO
line to the outside party "012-345-1011".
[Quick Dialing Table]
The leading number (in this case, "9") of the dialed number is found in the Quick Dialing Table, and the call is
automatically rerouted to the specified trunk group. It is necessary to specify a trunk group to make this type
of call. If the idle line access number is used in a destination number, the call will be rerouted through the same
private IP network according to the ARS programming, and the call will not be completed.
Quick Dialing No. Destination No.
9 802
Sending Faxes Through the Network
Through system programming, it is possible to select whether faxes are sent using analog or T.38 protocol
signals.
Conditions
[General]
• Some QSIG services are available. (® 15.1.17 PRIVATE NETWORK FEATURES—QSIG
)
• Toll Restriction (TRS) settings apply to calls rerouted to public CO lines. When making a call using System
Speed Dialing, regular TRS settings are applied, even if the TRS Override by System Speed Dialing feature
is enabled. (® 19.1.5 TRS (Toll Restriction))
[Common Extension Numbering for Multiple PBXs]
• System programming is required to enable this feature.
• If the called extension does not exist at the called PBX, the next PBX in the same gateway group is called
automatically.
• The Routing to Operator setting in system programming must be disabled to use this feature.
• To use this feature, all PBXs in the IP network must be KX-NS1000 PBXs, or KX-NCP/KX-TDE series
PBXs version 3.0000 or later.
Document Version 2016-03 Feature Manual 321
15.1.23 Private Network Features—VoIP (Voice over Internet Protocol)