Conditions
• In order to use the FWD to CO option, the ability to forward calls to CO lines must be enabled through
system programming.
• Extensions assigned as operators can be called by dialing [0], however, when setting this feature the
extension number
(not "0") must be specified.
PC Programming Manual References
10.7.1 PBX Configuration—[2-7-1] System—Class of Service—COS Settings
20.1.2 UM Configuration—[1-2] Mailbox Settings—Full Setting—Remote Call/Automatic Login/Direct Service
21.1 UM Configuration—[2] Class of Service
Operating Manual References
Subscriber Operation
1.6.5 Transferring Calls—
Remote Call Forwarding
Manager Operation
2.2.1 System Manager Features— Setting Class of Service (COS) Parameters
2.2.2 Message Manager Features
—
Remote Call Forwarding Set
20.1.76 Unified Messaging—Remote Time Service Set
Description
Allows the System Manager to program his or her extension from a remote location in order to change the
PBX's time service mode (day/night/lunch/break).
Operating Manual References
Manager Operation
2.2.1 System Manager Features— Remote Time Service Mode Setting
20.1.77 Unified Messaging—Send to Fax Machine
Description
Through the voice mail guidance, a subscriber can send received faxes to another destination. This feature
can be used to send received faxes to a fax machine to print them out.
The subscriber can send faxes to the following destinations:
• A preprogrammed fax machine
• A fax machine specified by entering its number via the telephone
• The fax machine the subscriber is calling from
(if calling from a fax machine)
The subscriber can select which faxes are sent, as follows:
• The current fax being "listened" to
• All unprinted faxes
• All faxes
428 Feature Manual Document Version 2016-03
20.1.77 Unified Messaging—Send to Fax Machine
To Next Page
Loading...
