Panasonic KX-NS1000 - 2.5.4.5 Reverse Circuit

[Programming Example: DID Table]
Location
1
2
DID
Name
*2
Sales
Judy
DID No.
*1
123-4567
123-2468
Day
Enable
Enable
Lunch
Disable
Disable
Night
Disable
Disable
Break
Enable
Disable
Day
105
102
Lunch
100
100
Break
105
102
CLI Distribution
*3
DID Destination
*4
Night
100
100
*1
® 18.3 PBX Configuration—[10-3] CO & Incoming Call
—DDI / DID Table—
DDI / DID Number
*2
® 18.3 PBX Configuration—[10-3] CO & Incoming Call
—DDI / DID Table—
DDI / DID Name
*3
® 18.3 PBX Configuration—[10-3] CO & Incoming Call
—DDI / DID Table—
CLI Ring for DDI/DID—Day, Lunch, Break, Night
*4
® 18.3 PBX Configuration—[10-3] CO & Incoming Call
—DDI / DID Table—
DDI / DID Destination—Day, Lunch, Break, Night
In this example:
If the DID number is "123-4567":
1. The PBX looks for the DID number in the table and finds it in location 1.
2. The PBX checks the time mode.
In
day mode: Calling Line Identification (CLI) distribution is enabled. The call is routed to its CLI destination,
if assigned. If not assigned, the call is routed to the DID destination, extension 105, and "Sales" is displayed.
In lunch mode: CLI distribution is disabled. The call is routed to the DID destination, extension 100, and
"Sales" is displayed.
Note
The following settings can also be specified in the DID table:
• Tenant number: determines the time mode
(day/lunch/break/night) for the corresponding CO line.
• UM service group number: determines the service group to use when a call is handled by the Unified
Messaging system.
• VM trunk group number: used in Voice Mail DPT (Digital) Integration with a VPS.
Conditions
• To use this feature, DID must be assigned as the distribution method for the desired CO line port.
PC Programming Manual References
10.3 PBX Configuration—[2-3] System—Timers & Counters—Miscellaneous—
Incoming Call Inter-digit
Timer—DDI / DID
18.2 PBX Configuration
—[10-2] CO & Incoming Call—DIL Table & Port Settings—DDI / DID / TIE
→
Distribution Method
→ DDI/DID/TIE—Remove Digit
→ DDI/DID/TIE—Additional Dial
18.3 PBX Configuration
—[10-3] CO & Incoming Call—DDI / DID Table
Feature Manual References
4.1.14 CLI (Calling Line Identification) Distribution
10.1.11 INCOMING CALL FEATURES
19.1.2 Tenant Service
19.1.3 Time Service
23.1 Capacity of System Resources
20.1.78 Unified Messaging—Service Group
Document Version 2016-03 Feature Manual 95
5.1.7 DID (Direct Inward Dialing)