Panasonic KX-NS1000 - Page 399

Required Programming
• PBX
For making a call:
ARS programming (® 2.8.1 Automatic Route Selection (ARS)) or TIE line service programming
For receiving a call:
TIE line service programming
[TIE Line Routing and Modification Table]
Location
No.
Leading
No.
Priority 1 Priority 2 . .
TRG
Dial Modification
TRG
Dial Modification . .
Removed
No. of
Digits
Added
No.
Removed
No. of
Digits
Added
No.
. .
01 2
2
(VoIP
port)
0
. .
02 3 2 0 . .
: : : : : : : : :
[Explanation]
Calls to destinations with leading number
"2" or "3" are automatically routed through the VoIP ports,
designated as trunk group 2.
• IP Gateway
IP address assignment for the local PBX and other PBXs.
[Programming Example]
Destination
Leading No. IP Address
2 200.45.11.35
3 199.176.64.1
: :
[Explanation]
Calls are routed to the IP address of each V-IPGW/IP-GW card based on the leading number dialled.
Automatic Rerouting of VoIP Calls to Public Trunks
When a
VoIP call cannot be completed successfully, the PBX can automatically attempt to make the call using
a public trunk instead. This provides a backup method of making calls in cases when IP network transmission
cannot be completed successfully.
Feature Guide 399
4.3.2 Voice over Internet Protocol (VoIP) Network