[From the Custom Service Diagram]
1. Double-click the desired Custom Service icon in the diagram, or right
-click on the desired icon and select
Edit.
2. Edit the parameters in the Custom Service parameters dialog box.
3. Click OK.
Example: Setting "Menu & Transfer"
1. Click Menu & Transfer under Custom Service Type and drag it to the right side of the screen.
2. Drop Menu & Transfer on to a position of your choice in the Custom Service diagram. The parameters
dialog box for the Custom Service opens.
3. Enter or select a value for each item.
For each parameter, refer to the description in the following section.
4. Click Record A Prompt For This Custom Service.
This feature is only available when setting "Menu & Transfer" or "Password". You can also skip this step,
and go to step 7.
5. Select Record from extension or Import from recorded file.
When Record from extension is selected:
1. Specify the extension number of the telephone used for recording, then click Connect.
2. When the specified extension rings, go off-hook.
3. Click Record, Play, or Stop to record or play a voice label through the extension.
4. Click Disconnect.
5. Click OK.
When Import from recorded file is selected:
1. Click the folder icon.
The Open dialog box appears.
2. Navigate to the folder containing the WAV files you want to open.
WAV files must meet the following specifications:
– G.711 PCM codec
– 8 kHz, 8-bit sampling rate
– Monaural
– A-law or µ-law encoding
3. Select the desired WAV file.
4. Click Open.
6. Click OK.
7. Click OK.
Document Version 2016-03 PC Programming Manual 1019
23.3 UM Configuration—[4-3] Service Settings—Custom Service
To Next Page
Loading...
