Panasonic KX-NS1000 - Page 1105

Service Name
If requested by the ISP, enter the PPPoE service name.
Default
Not stored
Value Range
0–24 characters
Maintenance Console Location
27.2.1 Router Configuration
—Setup—[1-2-1] WAN—Connection Settings
Authentication Method
Selects the authentication method.
Auto means that PAP, CHAP or None is selected for the necessary authentication.
Default
Auto
Value Range
Auto, CHAP
Maintenance Console Location
27.2.1 Router Configuration
—Setup—[1-2-1] WAN—Connection Settings
IP Address Configuration Mode
Selects the IP address configuration mode.
– Dynamic IP: Select this if the IP address is assigned by the ISP.
– Static IP: Select this if the ISP requires you to use a single global IP address.
– Unnumbered: Select this if the ISP requires you to use the multiple global IP addresses.
Default
Dynamic IP
Value Range
Dynamic IP, Static IP, Unnumbered
Maintenance Console Location
27.2.1 Router Configuration
—Setup—[1-2-1] WAN—Connection Settings
IP Address
Specifies the IP address when IP Address Configuration Mode is set to Static IP or Unnumbered.
If Static IP is selected for IP Address Configuration Mode, enter the IP address assigned by the DHCP
server.
If Unnumbered
is selected for IP Address Configuration Mode, enter one of the global IP addresses provided
by the ISP.
Document Version 2016-03 PC Programming Manual 1105
27.2.1 Router Configuration—Setup—[1-2-1] WAN—Connection Settings