Maintenance Console Location
27.12 Router Configuration—QoS Settings—[4] QoS Service
WAN QoS—Protocol No.—Select Protocol
Selects
the protocol name for which QoS is applied. This setting is available only if Select Protocol is selected
for WAN QoS—Protocol No..
Default
TCP
Value Range
ICMP, TCP, UDP, TCP&UDP
Maintenance Console Location
27.12 Router Configuration—QoS Settings—[4] QoS Service
WAN QoS—Protocol No.—Other ( 0 - 255 )
Specifies the protocol number for which QoS is applied. This setting is available only if Other ( 0 - 255 ) is
selected for WAN QoS—Protocol No..
Default
Blank
Value Range
Blank, 0–255
Maintenance Console Location
27.12 Router Configuration
—QoS Settings—[4] QoS Service
WAN QoS—Source
Selects the method of specifying a source.
If ANY is selected for Source, QoS is available for all IP addresses.
If Address is selected for Source, enter the IP address for IP Address below.
If Subnet is selected for Source, enter the subnet mask for Subnet Mask below.
Default
ANY
Value Range
ANY, Address, Subnet
Maintenance Console Location
27.12 Router Configuration
—QoS Settings—[4] QoS Service
1180 PC Programming Manual Document Version 2016-03
27.12 Router Configuration—QoS Settings—[4] QoS Service
To Next Page
Loading...
