Maintenance Console Location
28.1 Network Service—[1] IP Address/Ports—Advanced Settings
WAN Port—MDI/MDIX
Specifies the cable type connected to the WAN port.
Default
Auto
Value Range
Auto, MDI, MDIX
Maintenance Console Location
28.1 Network Service—[1] IP Address/Ports—Advanced Settings
WAN Port—Uplink
Specifies whether the WAN port data uplink is enabled.
Default
Enable
Value Range
Enable, Disable
Maintenance Console Location
28.1 Network Service—[1] IP Address/Ports—Advanced Settings
Maintenance Port—Speed & Duplex
Specifies
the connection mode of the maintenance port. The connection is made in 100Mbps/half duplex when
Auto negotiation fails. This setting is available at Installer level only.
Default
Auto
Value Range
Auto: Automatic mode selection
1000M-Full: 1000 Mbps/full duplex
100M-Full: 100 Mbps/full duplex
100M-Half: 100 Mbps/half duplex
10M-Full: 10 Mbps/full duplex
10M-Half: 10 Mbps/half duplex
Maintenance Console Location
28.1 Network Service—[1] IP Address/Ports—Advanced Settings
1194 PC Programming Manual Document Version 2016-03
28.1 Network Service—[1] IP Address/Ports
To Next Page
Loading...
