SLT Pulse Maximum Break Width
Specifies the maximum length of the break signal in a pulse dial.
Default
96 ms
Value Range
8 ´ n (n=9–20) ms
Maintenance Console Location
9.22 PBX Configuration
—[1-1] Configuration—Slot— SLC2 - Card Property
SLT Pulse Minimum Make Width
Specifies the minimum length of the make signal in a pulse dial.
Default
8 ms
Value Range
8 ´ n (n=1–5) ms
Maintenance Console Location
9.22 PBX Configuration
—[1-1] Configuration—Slot— SLC2 - Card Property
SLT Flash Detection
Enables
the PBX to detect the flash signal sent when an SLT user presses the hookswitch or the Flash/Recall
button.
Default
Enable
Value Range
Disable: The PBX disconnects the line to prevent placing the call on hold.
Enable: The PBX places the call on consultation hold.
Maintenance Console Location
9.22 PBX Configuration—[1-1] Configuration—Slot— SLC2 - Card Property
Feature Manual References
4.1.9 Call Splitting
Flash Timing - Min.
Specifies
the minimum length that a signal sent from an SLT must be for the PBX to recognize it as a hookswitch
flash signal.
424 PC Programming Manual Document Version 2016-03
9.22 PBX Configuration—[1-1] Configuration—Slot— SLC2 - Card Property
To Next Page
Loading...
