Panasonic KX-NS1000 - Page 455

Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: The port is not communicating with the network.
Maintenance Console Location
9.27 PBX Configuration
—[1-1] Configuration—Slot—Port Property - PRI Port
Subscriber Number
Specifies the number used as the CLIP number.
Default
Not stored
Value Range
Max. 16 digits (consisting of 0–
9, *, and #)
Maintenance Console Location
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port
Feature Manual References
4.1.15 CLIP (Calling Line Identification Presentation)
Ringback Tone to Outside Caller
Enables the PBX to send a ringback tone to an outside caller when the network cannot send the tone.
Default
Enable
Value Range
Disable, Enable
Maintenance Console Location
9.27 PBX Configuration
—[1-1] Configuration—Slot—Port Property - PRI Port
ISDN Outgoing Call Type
Selects the method used to send dialed digits to the network.
Default
CO port: En-bloc
QSIG (slave/master) port: Overlap
Document Version 2016-03 PC Programming Manual 455
9.27 PBX Configuration—[1-1] Configuration—Slot—Port Property - PRI Port