Programming Card Properties for cards installed in legacy gateways
For your reference, the following information is included on each Card Property screen for cards installed in
legacy gateways:
Site: The site number of the KX-NS1000 PBX to which the legacy gateway is connected.
Shelf: The shelf number of the STACK-M card Legacy Gateway connection:
• 2: Legacy-GW1
• 3: Legacy-GW2
Slot: The physical slot number within the legacy gateway where the card is installed.
Programming Port Properties for cards installed in legacy gateways
When programming KX-TDE/KX-NCP/KX-TDA PBXs using the Unified PC Maintenance Console, a
Command button is available to change the status (INS/OUS) of ports being programmed. To change the
status of a port when programming via Web Maintenance Console, click the desired cell in the Connection
column, and then select INS or OUS for the port.
Document Version 2016-03 PC Programming Manual 465
9.28 PBX Configuration—[1-1] Configuration—Slot—Legacy-GW1/Legacy-GW2
To Next Page
Loading...
