9.29 PBX Configuration—[1-1]
Configuration—Slot
—DOORPHONE Card—Card
Property
The doorphone card’s settings can be programmed.
The Shelf, Slot, and Port for each item are displayed for your reference. For details, see Common
Programming Reference Items in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Port Status
Specifies the port’s status.
This option is only available in On
-line mode.
Default
Current status
Value Range
INS: The port is in service.
OUS: The port is out of service.
Fault: There is a communication error.
Maintenance Console Location
9.29 PBX Configuration—[1-1] Configuration—Slot—DOORPHONE Card—Card Property
For Output - Device Type
Selects the type of connected output device
(for output ports only).
Default
No.1: Not stored.
No.2: Door Opener
No.3: Not stored.
Value Range
Ringer, Relay, Door Opener
Maintenance Console Location
9.29 PBX Configuration—[1-1] Configuration—Slot—DOORPHONE Card—Card Property
For Sensor - Input Signal Decision Time
Specifies the minimum duration of continuous input from the triggered sensor before the PBX recognizes the
input and makes a sensor call.
Default
No.1: Not stored.
No.2: Not stored.
No.3: 1024 ms
468 PC Programming Manual Document Version 2016-03
9.29 PBX Configuration—[1-1] Configuration—Slot—DOORPHONE Card—Card Property
To Next Page
Loading...
