2.1.6 Card Status
Certain tools, utilities and settings require that the target card be set to out
-of-service (OUS) or in-service
(INS) status before the operation is carried out. Where required, this is noted in the description of each item.
Card status changes can be performed only in On-line mode (see Programming Modes in
1.1.2 Introduction).
• "In service" means that the card is installed correctly in the PBX, and is capable of being used normally.
• "Out of service" means that the card is installed correctly in the PBX, but has been temporarily removed
from use. This allows settings to be modified or software to be upgraded.
• "Fault" means that the card is not installed in the PBX correctly, or is not functioning correctly. For more
information, see the Installation Manual.
For details about how to change the status of a card, see To change the status (INS/OUS) of a card (On-line
mode only) in 9.1 PBX Configuration—[1-1] Configuration—Slot.
Document Version 2016-03 PC Programming Manual 47
2.1.6 Card Status
To Next Page
Loading...
