Panasonic KX-NS1000 - 5.5.6 Dynamic Host Configuration Protocol (DHCP) Server

10.1.2 PBX Configuration—[2-1-2] System—Date & Time—SNTP /
Daylight Saving
Automatic
clock adjustment and Summer time (daylight saving time) settings of the PBX can be programmed.
Automatic clock adjustment can be performed using one of two methods, ISDN & Caller ID or SNTP (Simple
Network Time Protocol).
To set Summer time, click 10.1.2.1 PBX Configuration—[2-1-2] System—Date & Time—SNTP / Daylight
Saving—Daylight Saving.
Note
The NTP server function of the PBX must be enabled for connected KX
-UT series SIP phones to receive
automatic time adjustment information from the PBX. See 28.2.4 Network Service—[2-5] Server
Feature—NTP.
Automatic Time Adjustment—Synchronization mode
Specifies
the synchronization of the time between the Master unit and Slave units of a One-look network. For
the Master unit, only "Disable" can be selected.
Default
Disable
Value Range
Disable: Synchronization is not enabled (for the Master unit and Stand-alone units)
Enable: Synchronization is enabled (for Slave units)
Maintenance Console Location
10.1.2 PBX Configuration—[2-1-2] System—Date & Time—SNTP / Daylight Saving
Feature Manual References
2.1.8 Automatic Time Adjustment
Automatic Time Adjustment—Automatic
Time Correction on Stand-alone mode
Enables the PBX to automatically adjust its clock every day according to the time information provided by the
network.
Default
ISDN & Caller ID (FSK)
Value Range
Disable, ISDN & Caller ID (FSK), SNTP
Maintenance Console Location
10.1.2 PBX Configuration—[2-1-2] System—Date & Time—SNTP / Daylight Saving
Feature Manual References
2.1.8 Automatic Time Adjustment
Document Version 2016-03 PC Programming Manual 485
10.1.2 PBX Configuration—[2-1-2] System—Date & Time—SNTP / Daylight Saving