Panasonic KX-NS1000 - Page 744

Value Range
Not Stored, Loop CO, Single CO, Group CO, DSS, One-touch, ICD Group, Message Waiting, FWD/DND
(Both), FWD/DND (External), FWD/DND (Internal), Group Fwd (Both), Group Fwd (External), Group Fwd
(Internal), Account, Conference, Terminate
, EFA, Call Park, Call Log, Log-in/Log-out, Hurry-up, Wrap-up,
System Alarm, Time Service, Answer, Release, TRS Level Change, CLIR, COLR, Headset, Time Service -
Automatic/Manual, Check In, Check Out, Cleaned Up, Two-way Record, Two-way Transfer, LCS, Voice Mail
Transfer, NDSS, CTI, PDN, SDN, DN
Notice
For
each KX-UT series SIP phone that is connected to the PBX, at least one DN button must be assigned
to the extension. Without a DN button assigned, the extension will not be able to make or receive calls.
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Programming Manual References
12.1.4.1 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button—Flexible button data copy
Parameter Selection (for Single CO)
Specifies the CO line to be accessed.
Default
1
Value Range
1–600
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension
—Wired Extension—Flexible Button
Feature Manual References
4.1.16 CO Line Access
Parameter Selection (for Group CO)
Specifies the trunk group to be accessed.
Default
1
Value Range
1–96
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension
—Wired Extension—Flexible Button
744 PC Programming Manual Document Version 2016-03
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button