Panasonic KX-NS1000 - Page 746

Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Feature Manual References
19.1.3 Time Service
Parameter Selection (for TRS Level Change)
Specifies the TRS level to be used temporarily on a certain extension.
Default
Level 1
Value Range
Level 1–Level
7
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Feature Manual References
19.1.5 TRS (Toll Restriction)
5.1.6 Dial Tone Transfer
Parameter Selection (for Time Service - Automatic/Manual)
Specifies the Time Table to be used when the
Time Service Switching Mode is set to Automatic.
Default
Table 1
Value Range
Table 1–Table 32 or Table 1–Table 128
Note
The maximum number of time tables (1 per tenant) depends on the System Capacity Selection setting
made
when the Easy Setup Wizard was run for the PBX. If the System Resource Type was selected, the
maximum number of tenants (and therefore, time tables) is 128. If the SIP Extension Type or IP-Extension
Type was selected, the maximum number of tenants is 32. For details, refer to 5.4.1 Easy Setup
Wizard in the Installation Manual.
Maintenance Console Location
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button
Feature Manual References
19.1.3 Time Service
746 PC Programming Manual Document Version 2016-03
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button