Category Model
1 KX-NCP500
KX-NCP1000
KX-NS1020
2 KX-TDE100
KX-TDE200
KX-TDA100
KX-TDA200
3 KX-TDE600
KX-TDE620
KX-TDA600
KX-TDA620
4 KX-TDA100D
Example:
KX-NCP500 (category 1) and KX-NCP1000 (category 1): OK
KX-NCP500 (category 1) and KX-TDA100 (category 2): Not allowed
Notice
The following PBX models cannot be connected as legacy gateways:
• KX-TDA15
• KX-TDA30
Note
• For details about connecting a
KX-NS1020 as legacy gateways to KX-NS1000, refer to your
KX-NS1020 Installation Manual.
Condition 2 (KX-TDE100/KX-TDE200/KX-TDA100/KX-TDA200/KX-TDA100D only)
If you install the OPB3 card with an ECHO16 card, they must be installed in SLOT1 of the legacy gateway.
Condition 3 (KX-TDE600/KX-TDE620/KX-TDA600/KX-TDA620 only)
• The KX-TDE600 and KX-TDE620 must be disconnected from each other before connecting to a
KX-NS1000.
• The KX-TDA600 and KX-TDA620 must be disconnected from each other before connecting to a
KX-NS1000.
Installation Manual 169
4.6.1 STACK-M Card (KX-NS0130)
To Next Page
Loading...
