3. While the STATUS indicator is flashing green, slide the System Mode Switch back to the
"NORMAL"
position. Depending on the configuration, initialisation takes about 2.5 minutes. If successfully executed,
the STATUS indicator will stop flashing and remain lit up.
Note
For details about LED indications, refer to
"4.3.1 Mother Board" in the Installation Manual.
All data, except for system prompts and activation key files, will be erased. Data that is erased includes Unified
Messaging data, call logs, etc. The settings for the PBX as well as all optional service cards will be initialised
to their default values.
22 Getting Started
3.1 Starting the PBX
To Next Page
Loading...
