To call with the REDIAL button
Display PT
Press REDIAL to
display the outgoing
call log.*
1
Press REDIAL.
While on-hook
REDIAL
REDIAL
Press Up or Down
until desired name
and/or number*
2
appears.
Off-hook.
• This operation is available only for PTs with a display.
• *1 System programming is required for this operation.
• *2 After an outside call is made from the Outgoing Call Log, when another call is made
using the REDIAL button, if a name is registered to the Personal/System Speed Dialling
entry, the name is displayed on the LCD of the display PT making the call.
To store the caller’s information in personal speed dialling
Press STORE.
When the desired party is displayed
Display PT
• You can lock your call log display by using an extension PIN (Personal Identification
Number), so that you can prohibit access to your logged information (Display Lock). Refer to
"3.1.2 Settings on the Programming Mode".
• If a call arrives while you are using the call log, the call log display will be replaced with the
caller’s information.
1.14.2 Using the Directories
You can call using the directories (Personal Speed Dialling Directory, System Speed Dialling Directory and
Extension Number Directory).
Only personal directories can be stored, edited or deleted on your extension.
If a call arrives while you are using a directory, the display will be replaced with the caller’s information.
–
Calling with the Directory
–
Storing Names and Numbers
– Entering Characters
• PS users: Refer to the documentation for your PS.
1.14.2 Using the Directories
222 Operating Manual
To Next Page
Loading...
