For playback using the supervisor’s designated extension:
1. In the Mailbox filter, select the mailbox whose messages you want to display, and then click
Search.
2. Select the check boxes for one or more messages to play.
3. At the bottom of the screen, select Phone.
4. Click the (play) button.
Note
If ALL has been selected for the Mailbox filter, the (play) button will be disabled. Select a
specific mailbox to enable the
(play) button.
5. In the window that appears, enter the extension number in Specify Extension of the extension
at which to play back the messages, and then click Connect.
6. Go off-hook when the extension rings to establish a call with the UM message playback system.
7. During the call, click Play to listen to the currently selected message. If multiple messages were
selected in step a, you can click Prev and Next to cycle through and listen to the selected
messages.
8. When you are finished listening to messages, click Disconnect or go on-hook.
Logout
To logout of Web Maintenance Console, click the
(logout) button to end the programming session and
return to the Login screen. When this option is chosen, system data is automatically backed up from the
PBX to the Storage Memory Card.
1.
Click the
(logout) button.
A confirmation message will be displayed.
2.
Click Yes.
• If the computer running the Web browser that is connected to Web Maintenance Console is
shut down, or the Web browser is closed, any changes that have not been saved will be
lost. Always end your programming session by clicking the (logout) button. For more
information, consult your System Administrator.
3.2.1 User Programming
320 Operating Manual
To Next Page
Loading...
