Panasonic KX-NS1000 - 3.2.2.14 Fax Cover Page; 3.2.2.15 Fax Driver

3.1.2 Settings on the Programming Mode
You can programme features using the programming mode for a PT or PS.
– Setting Features
– Clearing Features
• To exit at any time, lift the handset.
• To enter the programming mode when using a PS, refer to the documentation for your PS.
• For KX-UT series SIP phone users and S-PS users: You cannot programme the following
features using a KX-UT series SIP phone or an S
-PS. These features are programmed via
Web Maintenance Console. For more information, consult your System Administrator.
Setting Features
The default settings are shown in bold letters. For later reference, place a check mark in the boxes below to
indicate your customised setting.
Notice
The default value may vary depending on country/area.
Follow
programming
input.
To programme To exit To enter the programming mode
Follow Selection
& Parameter.
Press PROGRAM
or PAUSE.
Press PROGRAM
or PAUSE.
selection &
parameter
programming
input
Press ENTER
or STORE.
Press ENTER
or STORE.
OR
OR OR
OR
PROG.
PROG.
PAUSE PAUSE
Item
Programming
Input
Selection & Parameter
Your extension information
0
0
The display shows your PT or PS’s
extension number.
<Example>
Ext 101
Display Contrast Selection
*1
Preferred display contrast
level from the 4 levels
available
0
1
1
Light
2
Little Light
3
Little Dark
4
Dark
302 User Manual
3.1.2 Settings on the Programming Mode