4.3.2 Registering IP Telephones
After the programming of the PBX and IP telephones is finished (refer to "4.3.1 Assigning IP Addressing
Information"), the IP telephones must be registered to the PBX. The procedure for registering IP telephones
differs according to the IP terminal registration mode specified during the Easy Setup Wizard. This setting can
also be changed in the Site Property—Main screen of the Web Maintenance Console (refer to "9.2.2 PBX
Configuration—[1-1] Configuration—Slot—System Property—Site—Main" in the PC Programming Manual).
Refer to the following table:
IP Terminals
IP Terminal Registration Mode
Full Automatic Mode
Extension Number
Input Mode
Manual Mode
IP-PTs
ü ü ü
KX-UT Series SIP
Phones
ü ü
*1
ü
Non-KX-UT series SIP
phones
ü
*2
ü
*2
ü
IP-CSs
*3
ü
ü: Available
*1
KX-UT series SIP phones will be registered automatically, in the same way as Full Automatic mode.
*2
Non-KX-UT series SIP phones must always be registered to the PBX manually, even if Full Automatic mode or Extension Number
Input mode is selected.
*3
IP-CSs must always be registered to the PBX manually. For details about registering IP-CSs, refer to the Quick Installation Guide for
the IP-CS.
Notice
You can specify an air sync group for IP-CSs after registration only when IP Terminal Registration Mode
is set to "Manual Mode".
Note
• For KX-UT series SIP phones, the SIP extension password is automatically set to "1234".
• For IP softphones, follow the same registration procedure as IP-PTs.
Full Automatic Mode
If networking settings have been completed, when IP-PTs or KX-UT series SIP phones are connected to the
same network as the PBX, they will be registered automatically. No registration procedure is required.
Extension Number Input Mode
For IP-PTs
If networking settings have been completed, when IP-PTs are connected to the same network as the PBX,
they will be registered automatically, but extension numbers for the IP-PTs will not be set. Follow the procedure
below to register an extension number to complete registration.
1. After completing networking settings, connect the IP-PT to the same network as the PBX. The screen to
enter the extension number is displayed on the IP-PT.
Getting Started 51
4.3.2 Registering IP Telephones
To Next Page
Loading...
