About the other manuals
Along with this Feature Guide, the following manuals are available to help you install, and use this PBX:
Installation Manual
Provides instructions for installing the hardware and maintenance of the PBX.
PC Programming Manual
Provides step-by-step instructions for performing system programming using a PC.
PT Programming Manual
Provides step-by-step instructions for performing system programming using a PT.
User Manual
Provides
operating instructions for end users using IP-PTs, DPTs, APTs, SIP phones, SLTs, PSs, or DSS
Consoles.
Other Information
Trademarks
• Microsoft and Outlook are either registered trademarks or trademarks of Microsoft Corporation in the United
States and/or other countries.
• The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use
of such marks by Panasonic Corporation is under license.
• All other trademarks identified herein are the property of their respective owners.
Note
• The contents of this manual apply to PBXs with a certain software version, as indicated on the cover
of this manual. To confirm the software version of your PBX, refer to How do I confirm the software
version of the PBX or installed cards? in 2.3 Frequently Asked Questions (FAQ) of the PC
Programming Manual, or [190] Main Processing (MPR) Software Version Reference in the PT
Programming Manual.
• Some optional hardware, software, and features are not available in some countries/areas, or for some
PBX models. Please consult your certified Panasonic dealer for more information.
• Throughout this manual, PT displays and other displays are shown in English. Other languages may
be available, depending on the country or area.
• In this manual, the suffix of each model number (e.g., KX-NS500NE) is omitted unless necessary.
• All system programming can be performed through PC programming (® 5.5.2 PC Programming).
However, only a subset can be performed through PT programming (® 5.5.3 PT Programming). In
Section 1 Call Handling Features and Section 2 System Configuration and Administration Features,
programming references that include a three-digit number, such as "000" indicate that system
programming can be performed through PT programming.
PC Programming
The number within the brackets indicates the system menu number for the Maintenance Console.
→ 14.1 PBX Configuration—[6-1] Feature—System Speed Dial—
CO Line Access Number +
Telephone Number
PT Programming
The number within the brackets indicates the programming number that is entered when performing
PT programming.
→ [001] System Speed Dialling Number
For further details, please refer to the PC Programming Manual and PT Programming Manual.
Feature Guide 3
Introduction
To Next Page
Loading...
