Mounting on a Wooden Wall
The included screws may be used when mounting the main unit on a wooden wall.
1. Measure the actual space as indicated below to mark the 3 screw positions on the wall.
2. Install the screws and washers (included) to the wall.
Washer
Drive the screw
to this position.
Note
• As indicated above, do not tighten the screw fully.
• The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
• Do not block the operations of the cabinet. Allow space of at least 20 cm above and 10 cm at the
sides of the cabinet.
• Make sure that screw heads are the same distance from the wall.
• Install the screw perpendicular to the wall.
3. Hook the main unit on the screw heads.
112 Installation Manual
4.2.10 Wall Mounting
To Next Page
Loading...
