Panasonic KX-NS500 - Page 113

Mounting on a Concrete Wall
The included screws may be used when mounting the main unit on a concrete wall. User-supplied anchor
plugs are also necessary.
1. Measure the actual space as indicated below to mark the 3 screw positions on the wall.
290 mm
100 mm
200 mm
2. Drill holes in the wall as marked and fit the anchor plugs (not included) into the holes.
Hammer
29 mm
Anchor Plug
6.4 mm
3. Fit the washers on the screws, and drive the screws into the anchor plugs.
Drive the screw
to this point.
Note
• As indicated above, do not tighten the screw fully.
• The pull-out strength of the installation area must be at least 294 N (30 kgf) per screw.
• Do not block the operations of the cabinet. Allow space of at least 20 cm above and 10 cm at the
sides of the cabinet.
• Make sure that screw heads are the same distance from the wall.
• Install the screw perpendicular to the wall.
Installation Manual 113
4.2.10 Wall Mounting