3. Insert the spacers (A) into the holes on the card, and tighten the spacers to secure the card.
Note
When using an MCSLC8 or MCSLC16 card with a DLC16
card, install the DLC16 card in the bottom
slot.
4. Connect cables to appropriate ports of the card. For details about pin assignments, refer to the appropriate
section in "4.5 Physical Trunk and Extension Cards".
Note
Make sure to connect cables after installing the card in the PBX, not before.
96 Installation Manual
4.2.5 Installing/Removing the Optional Service Cards
To Next Page
Loading...
