Panasonic KX-NS700 - Customizing the Buttons

3.1.4 Customizing the Buttons
You can customize the flexible buttons and/or programmable feature (PF) buttons on PTs, Add-on Key
Modules, and PSs. They can then be used to make or receive outside calls or as feature buttons.
• To enter the programming mode when using a PS, refer to the documentation for the PS.
• The buttons in the table below can only be set on certain flexible buttons, as follows:
– Flexible buttons on PTs/Add-on Key Modules/PSs: all buttons can be set.
– Flexible buttons on DSS Consoles: all buttons except CTI and Primary Directory Number
(PDN) buttons can be set.
– Programmable feature (PF) buttons: only the One-touch Dialing button can be set.
• For KX-UT series SIP phone users: You cannot customize the flexible buttons with the
following method from your phone. You can customize the flexible buttons using Web
Maintenance Console. For details, refer to "Customizing the Flexible Buttons".
Press PROGRAM
or PAUSE.
Press PROGRAM
or PAUSE.
Press desired
flexible button.
Follow
programming
input.
programming
input
OR
PAUSE
OR
PAUSE
Press ENTER
or STORE.
OR
To exit
To program
To enter the program mode
To continue
Button
Programming Input
Loop-CO (L-CO)
Group-CO (G-CO)
#
+ CO line group no. (2 digits)
Single-CO (S-CO)
0
+ CO line no. (3 digits)
Direct Station Selection (DSS)
1
+ Extension no.
*12
One-touch Dialing
*1
2
*2
+ Desired no. (max. 32 digits)
Incoming Call Distribution
Group (ICD Group)
3
0
+ Incoming call distribution group extension no. (+
#
+ delayed ringing time [0–7])
*3
Message
4
0
Message for Another Extension
4
0
+ Extension no./Incoming call distribution group extension
no.
Call Forwarding (FWD)/Do Not
Disturb (DND)—Both calls
4
1
FWD/DND—Outside calls
4
2
FWD/DND—Intercom calls
4
3
Document Version 2014-11 Operating Manual 293
3.1.4 Customizing the Buttons