Customising Your Phone & System
248 User Manual
4.3.6 Caller ID Dial Set (006)
You can set the identification code of the calling party (Caller ID Code) to utilise Caller ID Service
provided by a specific Central Office (CO). If an ID Code transmitted from CO is found in the Caller
ID Code Table, the Caller's ID Code or a name given to the code in "4.3.7 Caller ID Name Set (007)"
is displayed on the display PT, allowing the called party to recognise the caller.
Default: All locations: Not Stored
• Up to 1000 Caller ID Codes (a maximum of 24 digits for each consisting of 0-9, or #) per
tenant, 2000 per system can be assigned.
• Programme "4.3.7 Caller ID Name Set (007)" is used to give names to Caller ID Codes.
If an ID Code is given a name, the called party's display PT shows the name with the Caller
ID Code.
Press NEXT.Dial 006.
NEXT
Press STORE.Enter location
number (000-999).
Enter Caller ID number
(max. 24 digits).
STORE
Press END.
END
location no.
Caller ID no.
SELECT
PREVNEXT
Press SELECT.
Press NEXT. Press PREV.
OR
To continue
To end
0 0 6
To Next Page
Loading...
