Telephone Features 3-47
3.2 Telephone Features C
Conditions
• You can return to the original party by pressing the FLASH/RECALL button again.
• You can return to the original party by repeating the steps above.
• If “Hold-3” is assigned in System Programming, you must dial “20” after flashing the
hookswitch.
Programming References
System Programming — Installation Manual
[104] Hold Mode Selection
[110] Flash Key Mode
[418] Flash Time
Feature Reference
External Feature Access
SLT
SLT
PT
Call Waiting from a Central Office
During a conversation, a Call Waiting tone offered by your Central Office signals you
that there is a call waiting. You can respond to the call by placing the first call on hold.
• The current call is placed on hold. • The current call is placed on hold.
PT SLT
Talk to the new caller.
While hearing a Call Waiting tone
through the handset
Flash the hookswitch. Dial 6.
Talk to the new caller.
Press FLASH/RECALL.
While hearing a Call Waiting tone
through the handset
FLASH/RECALL
6
To Next Page
Loading...
