Panasonic KX-TA616 - Before System Programming; Programming Sequence

System Programming 4-3
4.1 Before System Programming
To enter the programming mode
• The system password can be changed by program [002] “System Password”.
• During the programming mode, your extension is treated as a busy extension.
• If you enter the wrong system password, you will hear an alarm tone (3 beeps). Try
again.
Programming sequence
After entering the programming mode
After pressing the STORE button, you will hear one of the following tones.
Confirmation tone (1 beep): This informs you that storing is completed. You can
continue programming by entering the same or another
program address
(2 beeps): This informs you that the same parameter has already been
stored.
Alarm tone (3 beeps): This informs you that the entry is invalid.
To exit the programming mode
Enter the Program Address. Enter the parameters. Press the END
button.
!
!
X
X
X
END
parameters
system password
#
Enter the system password.
(default : 1234)
Press #.
SET PROGRAM
MEMORY
Set to “PROGRAM” on
the back of the telephone.
Press the
STORE button.
STORE
PROGRAM
Press the PROGRAM
button.
or
SET PROGRAM
MEMORY
Set to “SET” on the back
of the telephone.
PROGRAM
Press the PROGRAM
button.
or
1
23
456
789
0
SECRET
SELECT
CLEAR
PAUSE
STORE
NEXTENDFLASHPREV
, –
AUTO
KX-T7130