Panasonic KX-TA616 - Pause Time

4-50 System Programming
[414]-[417] 4.2 System Programming
Assigns the length of the pause time. The programmed pause time is automatically inserted
after a line access code, a host PBX access code programmed in [403] “Host PBX Access
Codes” or a pause code assigned in [311] “Automatic Pause Insertion Codes” or can be
manually inserted by the user using the PAUSE button.
* Outside (CO) line number: 1 through 6 / (All outside lines)
Default All outside (CO) lines – 1.5 seconds
• Feature Reference
Section 3, Features
Host PBX Access
[417] Pause Time
7
1
4
NEXT
SELECT
(1.5/2.5/
3.5/4.5 sec)
END
outside line no.*
(1 ··· 6/ )
☞
To continue
NEXT
PREV
or
To continue
STORE
• You must select “DISA1”when the optional OGM/FAX Detection card is not installed
and if you want to use the internal DISA.
• When you select “UCD”, assign program [520] “UCD Group” to determine which
extension group is assigned to the UCD group.
• When you select “DISA1”, “DISA2” and/or “UCD”, assign program [502] “OGM Mode
Selection” to determine which OGM will be used.
• Feature References
Section 3, Features
Direct In Line (DIL), Direct Inward System Access (DISA),
Outgoing Message (OGM), Uniform Call Distribution (UCD)
!
!
☞
SELECT