Panasonic KX-TA624 - Dss (Direct Station Selection) Button; Trunk Group (G-Co) Key

1-10 Operations
1.2 Proprietary Telephone Settings
PT
DSS (Direct Station Selection) Button
Press the programmable button.
Press STORE.Dial 1.
1
AUTO DIAL
STORE
extension no.
Enter an extension number.
CO
MESSAGE
Trunk Group (G-CO) Key
To use exchange lines efficiently, a group of exchange lines (trunk group) can be assigned to a
line key. This button is referred to as Trunk Group (G-CO) key. Any incoming calls from any
exchange line in the trunk group arrive at the G-CO key. To make an outside call, you can
access an idle exchange line in the group by simply pressing the assigned G-CO key.
• The same line can be assigned as a S-CO key and G-CO key.
• The exchange lines for making and/or receiving calls in trunk groups must be
pre-programmed.
• When your extension is assigned as the incoming call destination for an exchange line, you
cannot receive any incoming exchange line calls unless a G-CO, O-CO or S-CO key
associated with the line is assigned.
PT
Press the programmable button. Dial #. Enter a trunk group number (1 through 6).
Press STORE.
AUTO DIAL
STORE
CO
trunk group no.
#
!
!
• 1.3 Making Calls, “Intercom Calling”
☞
PSQX1709ZA-02.QX 99.10.15 9:55 AM Page 10