2-16 Installation
2.13 Printer and PC Connection
Circuit Type
EIA CCITT
BB 104
BA 103
CD 108.2
AB 102
CC 107
CA 105
CB 106
Pin
No.
2
3
4
5
6
7
8
A user-supplied printer or personal computer (PC) can be connected to the system. These
are used to print out or refer to the SMDR call records and system programming data.
Connect the printer cable or the PC cable to the Serial Interface (RS-232C) connector. The
cable must be shielded and the maximum length is 2 m.
Serial Interface
(RS-232C) (D-SUB, 9-pin)
Printer or Computer
Arrange the cables so that the printer will be connected to the system as shown in the
appropriate chart on the following page.
The pin configuration of the Serial Interface (RS-232C) Connector is as follows.
Signal Name
RXD Received Data
TXD Transmitted Data
DTR Data Terminal Ready
SG Signal Ground
DSR Data Set Ready
RTS Request To Send
CTS Clear To Send
PSQX1708ZA-03E.QX 99.10.15 5:46 PM Page 16
To Next Page
Loading...
