2-32 Installation
2.21 Starting the System for the First Time
1. Set the Power Switch to the “OFF” position.
2. Plug the AC power cord into the system and an AC outlet.
3. Turn the Power Switch on.
(The power indicator will light.)
4. Perform the following operation with a proprietary telephone connected to JACK 01.
a) Set the MEMORY switch to “PROGRAM” on the back of the telephone.
b) Press #.
c) Enter 1234.
d) Enter 999.
e) Press the NEXT (SP-PHONE) button.
f) Press the SELECT (AUTO ANSWER/MUTE) button until
“All Para” is displayed.
g) Press the STORE (AUTO DIAL/STORE) button.
h) Press the END (HOLD) button.
i) Set the MEMORY switch to “SET” on the back of the telephone.
The system will be initialised with the default values. If the system does not work properly,
please see 2.23, “System Data Clear”.
CAUTION • The system will continue to be powered even if the Power Switch is turned
“OFF”.
• The power supply cord is used as the main disconnect device. Ensure that the
outlet is located/installed near the equipment and is easily accessible.
PSQX1708ZA-03E.QX 99.10.15 5:47 PM Page 32
To Next Page
Loading...
