Panasonic KX-TA824 - Call Waiting Caller ID Time; Call Waiting Caller ID Cas Receive Time

9.9 Caller ID [9]
Programming Manual 221
Default
Off
Value Range
On (checked), Off (unchecked)
Programming Manual References
[907] Caller ID SMDR Printout
Feature Manual References
1.1.30 Caller ID
1.1.112 Station Message Detail Recording (SMDR)
Call Waiting Caller ID Time
Selects the length of time that the Call Waiting Caller ID feature sent from the telephone company is shown
on the display of the proprietary telephone (PT). The TRANSFER button, HOLD button, and CONF button
do not function during the assigned time.
Default
30 s
Value Range
10 s, 20 s, 30 s, 40 s, 60 s, 120 s
Programming Manual References
[908] Call Waiting Caller ID Time
Feature Manual References
1.1.28 Call Waiting Caller ID
Call Waiting Caller ID CAS Receive Time
This program is available when the Caller ID and Call Waiting Caller ID features are enabled in CO Line
Settings—Caller ID and CO Line Settings—Call Waiting Caller ID respectively on this screen.
If the extension user has a Call Waiting Caller ID during a conversation, the telephone company will send
an alert tone (CAS) to the PBX. If the CAS duration is too long or too short, the CAS is ignored by the PBX.
If the CAS is accepted, then the PBX will respond and the Call Waiting Caller ID feature will be performed.
This program assigns the allowable CAS duration. Normally, it should not be necessary to change the
default setting.
Default
72–96 ms
Value Range
40–120 ms, 64–96 ms, 72–96 ms