Panasonic KX-TA824 - Doorphone Chime Assignment; Doorphone Chime Pattern; SMDR RS-232 C Parameter

2.2 PT Programming—Procedures
68 Programming Manual
[711] Doorphone Chime Assignment
Selects the relay to which a doorbell or a door chime is connected, for use when "Chime" or "Ring & Chime"
is selected in
[710] Doorphone Ring/Chime.
Conditions
• A relay not connected to a door opener should be selected.
Programming Manual References
[710] Doorphone Ring/Chime
Feature Manual References
1.1.47 Doorbell/Door Chime
1.1.48 Doorphone Call
[712] Doorphone Chime Pattern
Selects the doorphone chime pattern for incoming doorphone calls. Chime patterns 1–4 are played only one
time during the doorphone ringing time.
Feature Manual References
1.1.47 Doorbell/Door Chime
1.1.48 Doorphone Call
2.2.1 Tones/Ring Tones
[800] SMDR RS-232C Parameter
Specifies the following communication parameters for the Serial Interface (RS-232C port):
a. New Line (NL) Code: Select the code appropriate for the PC or printer. If the PC or printer
automatically feeds lines with carriage return, select "CR". If not, select "CR+LF".
b. Baud Rate: Baud rate indicates the transmission speed of data from the PBX to the PC or printer.
c. Word Length: Word length indicates how many bits compose each character.
7 1 1
NEXT
doorphone no. name*
STORE END
(1
…
4/ )
SELECT
SELECT
NEXT PREV
or
To continue
To continue
(Relay1
…
4)
Relay4
7 1 2
NEXT
doorphone no. name*
STORE END
(1
…
4/ )
SELECT
SELECT
NEXT PREV
or
To continue
To continue
(Pattern 1
…
8)
Pattern 1