2.2 Installing the Advanced Hybrid System
32 Installation Manual
Mounting on a Concrete or Mortar Wall
The included screws may be used when mounting the main unit on a concrete or mortar wall. User-
supplied anchor plugs are also necessary.
1. Place the template (found on the last page of this manual) on the wall to mark the 3 screw
positions.
Note
When you print out the template, the distance on the paper output may deviate slightly from the
indicated measurement. In this case, use the indicated measurement.
2. Drill holes in the wall as marked and fit the anchor plugs (not included) into the holes.
3. Fit the washers on the screws, and drive the screws into the anchor plugs.
4. Affix the PBX to the screw heads.
Template
Hammer
29 mm
(1-1/8 in)
Anchor Plug
6.4 mm
(1/4 in)
Drive the screw
to this point.
To Next Page
Loading...
