Panasonic KX-TA824 - Lockout

1.3 Telephone Features
Operating Manual 103
To listen to messages
1.3.58 Lockout
If one party in a conversation goes on-hook, the call between both parties will be disconnected. A reorder
tone is sent to the off-hook party before the call is disconnected. No operation is necessary. For more
details, refer to "1.1.79 Lockout" in the Feature Manual.
• If your telephone company sends a special signal (Stutter dial tone) when you seize the
outside (CO) line, this is an indication that a new message was recorded. Approximately
5 seconds after the user hangs up one of the preprogrammed outside (CO) lines, or 3
minutes 46 seconds after the phone stops ringing, the PBX automatically seizes the line
and checks if a message has been recorded. If a new message was recorded in the
mailbox of the telephone company, the Message/Ringer Lamp lights red and the
corresponding S-CO button flashes red moderately.
• If your voice mail service uses a stutter dial tone and the recorded message is over 3
minutes long, in some cases the Message/Ringer Lamp may not light and the
corresponding S-CO button may not flash.
• A contract with your telephone company may be required for local carrier-based voice mail
service. For more details, consult your telephone company.
Programming Manual References
[PT Programming]
• [435] Local Carrier-based Voice Mail Signaling
• [436] Local Carrier-based Voice Mail Access Dial
• [437] Extension Access to Local Carrier-based Voice Mail
[PC Programming]
• 9.3.4 Local Carrier-based VM [3-4]
Feature Manual References
• 1.1.78 Local Carrier-based Voice Mail Service
Operating Manual References
• 3.1.3 Flexible Button Assignment
Create or edit a Single-CO (S-CO) button or Message button.
Press MESSAGE.
Off-hook.
PT
When the Message/Ringer Lamp is lit and an S-CO button flashes red at moderate speed
Press S-CO.
(S-CO)