Panasonic KX-TAW848 - Leading Number Exception [8-6]

4.14 ARS [8]
544 Feature Guide
Feature Guide References
1.9.1 Automatic Route Selection (ARS)
Authorization Code for TRG
Specifies an Authorization code for each CO line group. The Authorization codes can be added to the user-
dialed number by specifying "G" command in Modify Command on the Carrier tab.
Authorization Code for Trunk Group—TRG 01–TRG 64
Specifies the Authorization code of each carrier for each CO line group.
Default
Not stored.
Value Range
Max. 10 digits (consisting of 0–9, *, and #)
Programming References
None
Feature Guide References
1.9.1 Automatic Route Selection (ARS)
4.14.6 Leading Number Exception [8-6]
Specifies telephone numbers that will not be connected using the ARS feature. When the user-dialed
number includes a leading number exception, the PBX sends the number to a CO line by the Idle Line
Access method if ARS Mode in System Setting [8-1] is "on". A maximum of 200 different leading number
exceptions can be programmed.
Leading Number Exception
Specifies the leading number exception.
Default
Not stored.
Value Range
Max. 16 digits (consisting of 0–9, *, #, and X)
Note
"X" can be used as a wild card character which substitutes any digit in its position.
Programming References
None