Panasonic KX-TCD410AXM - Replacing the Batteries

- When using Ni-Cd batteries (250 mAh):
Talk time: 4hrs approx.
Standby time: 40hrs approx.
(Times indicated are for peak performance)
- The batteries reach peak performance after several full charge/
discharge cycles.
- The batteries cannot be overcharged unless they are repeatedly
removed and replaced.
- If battery life is shortened then please check that battery and charge
terminals are clean.
- For maximum battery life, it is recommended that the handset is not
recharged until battery icon flashes
.
4.4. Replacing the Batteries
If the icon flashes after a few telephone calls even when the handset batteries have been
fully charged, 2 batteries must be replaced.
Charge new batteries for approximately 7 hours before initial use.
(The telephone line cord must not be connected to the telephone socket at this time).
When replacing the batteries, ensure that the correct battery type is selected.
- To exit the operation, press any time.
- Do not use non-rechargeable batteries. If non-rechargeable batteries
are fitted and start charging, it may cause the leakage of the battery
electrolyte.
Please use only Panasonic HHR-4EPT(Ni-MH) or P-4NPT(Ni-Cd) batteries.
6
www.freeservicemanuals.info
11/8/2014
Digitized in Heiloo, Holland