Panasonic KX-TCD410AXM - How to Replace Flat Package IC

Address Default Name
Country
Setting
Type Description
0F36 46 GR-offset for
volumestep 1
x D Bit7: AOG
Bit6: AOG2
Bit5, bit0: Gain-receive (values ranging
from 0x00 to 0x30, each step representi
1 dB)
0F37 5F GR-offset for
volumestep 2
x A Bit7: AOG
Bit6: AOG2
Bit5, bit0: Gain-receive (values ranging
from 0x00 to 0x30, each step representi
1 dB)
0F38 46 GR-offset for
volumestep 3
00 D Bit7: AOG
Bit6: AOG2
Bit5, bit0: Gain-receive offset to
volumestep 2 (values ranging from 0x0
0
0x30, each step representing 1 dB)
0F3F 02 EEVoiceVolume x D Volume of the earpiece
28.3.5. VolumeSetting Second Block
Address Default Name
Country
Setting
Type Description
0F53 FF Menu Config x D bit 0 - Registration menu on/off 1/0
bit 1 - Select base menu on/off 1/0
bit 2 - Internal ringer menu on/off 1/0
bit 3 - Page ringer menu on/off 1/0
bit 4 - Standby mode menu on/off 1/0
bit 5 - Battery select menu on/off 1/0
bit 6 - Call wating menu on/off 1/0
bit 7 - Clip list on/off 1/0
0F54 01
RecVolStoreEnabled
x D 00: Reciever volume will be reset to def
a
value when hooking on.
01: Reciever volume will be stored in
eeprom when set in conversation.
29. HOW TO REPLACE FLAT PACKAGE IC
29.1. Preparation
- PbF (: Pb free) Solder
- Soldering Iron
Tip Temperature of 700°F ± 20°F (370°C ± 10°C)
Note: We recommend a 30 to 40 Watt soldering iron. An expert may be
able to use a 60 to 80 Watt iron where someone with less experience
could overheat and damage the PCB foil.
- Flux
71
www.freeservicemanuals.info
11/8/2014
Digitized in Heiloo, Holland