Setting the Handset and Base Unit
34
*
1
After you set the PBX type, disconnect and reconnect the telephone cord.
*
2
To check the type of PBX you are using, see page 30.
*
3
When a check mark is displayed beside a tone type, the incoming call log for that tone type
will be logged.
• These settings are only applied to your telephone, not the PBX itself.
Main Item Description Setting Default
Selects the type of PBX that
the base unit is connected to.*
1
Ty p e 1 *
2
Ty p e 2
Type 1
When using a PBX other than
a KX-TAW848/KX-TDA series
PBX, you do not need to
change this setting.
Mode 1
Mode 2
Mode 1
“
PBX Type-Type 1
(KX-TA1232)” only
Selects which line of information
is displayed as Caller ID. When
the Caller ID matches an item
stored in the Phonebook, the
handset rings according to the
setting of the item. As shown
below, a caller’s number, caller’s
name and CO line number are
displayed on each line.
Displayed items vary depending
on your PBX and its settings.
1st Line
2nd Line
3rd Line
1st Line
“
PBX Type-Type 2
(KX-TD series)” only
Sets the current date and time
for the base unit.
Date
Time
01-01-05 (D-M-Y)
12:00 AM (H:M)
“
PBX Type-Type 2
(KX-TD series)” only
Sets each type of Incoming
Call Log to either on or off.*
3
You must set at least one of the
incoming call types to on to
store a received call in the
Incoming Call Log.
Single Tone
On
Off
Double Tone
On
Off
Triple Tone
On
Off
Single Tone: Off
Double Tone: Off
Tr ip le Ton e: Of f
PBX Type
Fwd/DND Icon
Caller ID Line
CO01:
01234567890
T.Edison
1st Line
2nd Line
3rd Line
<Example>
Date&Time
Incoming Log
To Next Page
Loading...
